Table of Contents
Advertisement
Power/Warning Indicators
When an indicator lights up
If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f Before you take a remedial measure, follow the procedure of switching the power off indicated in "Powering Off the
Projector" (x page 36).
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Power indicator
<ON(G)/STANDBY(R)>
Off
Lighting
Lighting
Red
Lighting
Blinking
92 - ENGLISH
Chapter 6 Maintenance - Power/Warning Indicators
Warning
indicator
Status
<WARNING>
The power cord is
Off
unplugged.
The power cord is plugged.
Off
The projector is in standby
mode after the cooling is
completed.
The replacement time of
Lighting in red
the lamp unit is displayed.
(Standby mode)
It has exceed the replace-
ment time of the lamp unit
Blinking in red
and the projector is turned
off automatically.
The projector inside is
cooling down and after
a while, the projector is
Off
turned off. (The projector
will enter into the standby
mode)
Cause
--
--
--
f The indicator lights up
when the usage time of
the lamp unit reaches
6 000 hours (when
[Lamp control] is set to
[
(Eco 1)]).
f Replace the lamp
f The indicator blinks
when the usage time of
the lamp unit reaches
6 600 hours (when
[Lamp control] is set to
[
(Eco 1)]).
--
Solution
--
--
--
unit.
--
Advertisement
Table of Contents
