Table of Contents
Advertisement
Preparing the remote control
Inserting and Removing batteries
(i)
1)
Open the cover. (Fig. 1)
2)
Insert batteries and close the cover (Insert the "m" side first.). (Fig. 2)
f When removing the batteries, perform the steps in reverse order.
When using the multiple projectors
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector
individually using single remote control, if unique ID number is assigned to each projector.
When you want to set the ID number, at first you need to set the ID number of the projector, and then set the ID number on the
remote control.
The factory default ID number of the unit (the projector and the remote control) is set to [ALL], you can control with this setting.
If necessary, please set the ID number to the remote control and the projector.
About how to set the ID number of the remote control, please refer to "Setting the remote control ID numbers". (x page 42)
Note
f Set the ID number of the projector from the [Expand] menu → [Remote control]. (x page 69)
24 - ENGLISH
Chapter 1 Preparation - Preparing the remote control
(ii)
Fig. 1
(ii)
(i)
Fig. 2
Advertisement
Table of Contents
