Power/Warning Indicators - Panasonic PT-LB355U Operating Instructions Manual

Power/Warning Indicators

If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f Before you take a remedial measure, follow the procedure of switching the power off indicated in "Powering Off the
Projector" (x page 37).
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Power indica- Warning
tor <ON(G)/ indicator
STANDBY(R)> <WARNING>
Off
Blinking Lighting in red
Red
Blinking Blinking in red
Lighting Lighting in red
Green
Lighting Blinking in red
Blinking
Chapter 6 Maintenance - Power/Warning Indicators
Status
The power plug is not
Off
connected to the outlet.
It has reached the replace-
ment time of the lamp unit.
It has exceeded the replace-
ment time of the lamp unit
and the projector is turned off
automatically.
The replacement time of the
lamp unit is displayed. (Pro-
jecting)
It has exceeded the replace-
ment time of the lamp unit
and the projector is turned off
automatically.
The power cord is plugged
Off
and the lamp is turned off.
(Ready state)
Cause
--
f The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f The indicator blinks when
the usage time of the
lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f Is the lamp replacement
warning icon
displayed when turn on
or turn off the projector?
f The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f The indicator blinks when
the usage time of the
lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f [Power management] is set to [Ready].
If a video signal is input in Ready mode, or when you
press any button other than the power
<v/b> button, the luminous lamp turns on and the
projector enters the projection state. Pressing the
power <v/b> button during the Ready state will enter
the standby state. (x page 69)
Solution
Connect the power plug to
an outlet.
f Replace the lamp unit.
f Replace the lamp unit.
ENGLISH - 93