Power/Warning Indicators - Panasonic PT-TX340 Operating Instructions Manual

Power/Warning Indicators

If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f Before you take a remedial measure, follow the procedure of switching the power off indicated in "Powering Off the
Projector" (x page 36).
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Power indicator
<ON(G)/STANDBY(R)>
Off
Blinking
Red
Blinking
Lighting
Green
Lighting
Blinking
Chapter 6 Maintenance - Power/Warning Indicators
Warning
indicator
<WARNING>
The power plug is not
Off
connected to the outlet.
It has reached the replace-
Lighting in red
ment time of the lamp unit.
It has exceeded the re-
placement time of the lamp
Blinking in red
unit and the projector is
turned off automatically.
The replacement time of
Lighting in red the lamp unit is displayed.
(Projecting)
It has exceeded the re-
placement time of the lamp
Blinking in red
unit and the projector is
turned off automatically.
The power cord is plugged
Off and the lamp is turned off.
(Ready state)
Status
f The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f Is the lamp
replacement warning
icon
displayed when turn
on or turn off the
projector?
f The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f [Power management] is set to [Ready].
If a video signal is input in Ready mode, or when
you press any button other than the power
<v/b> button, the luminous lamp turns on
and the projector enters the projection state.
Pressing the power <v/b> button during
the Ready state will enter the standby state.
(x page 68)
Cause Solution
Connect the power plug
--
to an outlet.
f Replace the lamp
unit.
f Replace the lamp
unit.
ENGLISH - 91