Table of Contents
Advertisement
Projecting
Check the connections of the peripheral devices (
on the power (x page 35) to start the projector. Select the image and adjust the state of the image.
Selecting the input signal
Select an input signal.
1)
Press the <INPUT/ENTER> button on the control panel or the input selection (<COMPUTER 1>, <COMPUTER 2>,
<HDMI>, <VIDEO> or <MEMORY VIEWER/USB DISPLAY/NETWORK>) buttons on the remote control.
f The image of the signal being input in the selected terminal is projected.
Attention
f Images may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Select a
system format that is suitable for the input signal in [Display] menu → [System] (x page 51).
f Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [Display] menu →
[Aspect] (x page 50).
How to adjust the state of the image
When setting up the projector for the first time or setting up at a new place, you must perform the following operations.
1)
Adjust the projection angle.
f Install the projector on a flat surface and parallel to the screen so that the projected screen is rectangular.
f If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the projected screen
is rectangular.
f For details, see "Adjusting adjustable feet" (x page 29).
2)
Adjust the focus.
f Rotate the focus ring to adjust the focus of the projected image.
Note
f It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
f If you adjust the focus, you may need to adjust the size of the image by changing the distance between the screen and the
projector.
f If keystone distortion occurs, see the [Expand] menu → [Keystone] (x page 61).
Chapter 3 Basic Operations - Projecting
Æ
page 30) and connection of the power cord (x page 34) and switch
Focus ring
ENGLISH - 37
Advertisement
Table of Contents
