Russound MCA-C3 User And Installation Manual page 110

4. Open the "WakeOnLanGui.exe" icon
From Step 3 type the "IP Address" in the "Internet Address" window.
From Step 3 type the "Subnet Mask" in the "Subnet Mask" window.
Place the MCA-C3 under test MAC ID in the "MAC Address" window.
Set the "Send Options" window to "Local Subnet"
The "Remote Port Window" is set to "7".
Observe the MCA-C3 Ethernet Port "Yellow" LED, it should be dark.
The "Yellow" LED will blink when the packet is sent.
Click the "Wake Me Up" button and a Magic Packet is sent to the MCA-C3.
Repeat this test if needed to confirm the "Yellow" LED blinks.
Note: This command is being sent to the Ethernet Port
5. All MDK-C5 Keypads clocks will be visible.
D36 on the Digital Board will be blinking again
and you hear a relay click in the MCA-C3. (The MCA-C3 is not in Sleep Mode).
Press the power button on MDK-C5 Rev 1 Zone 1 to turn it on.
MDK-C5 Rev 1 Zone 1 will illuminate and display "One".
(This prevents the MCA-C3 from going to sleep every 10 seconds)
6. Press the space bar to start the "UEI and Learned IR" group.
7. Continue by performing the "UEI and Learned IR"
MCA-C3 Test Procedure
Page 68 of 77
and the GUI will display.
section.