Table of Contents
Advertisement
Operation
7
Operation
7.1 Starting and stopping the device
Starting
36
Carry out the following steps to take the unit into operation:
1.
Check to see whether all laser safety precautions have been taken. Make sure that
nobody is in range of the laser beam.
2.
Insert the safety key into the lock (9).
3.
If not already done, connect the device to a mains power outlet (7).
4.
Turn the unit on using the main switch (5). After a few seconds, the fan and the motors
start to work. The display shows the current operating mode. The unit is now opera‐
tional.
5.
Turn the safety key (9) into the 'ON' position to turn the laser beam on.
showlaser
Advertisement
Table of Contents
