Waeco coolair rt880 Operating Manual page 36

Using the parking cooler
7.2 Switching on the parking cooler
A
NOTICE!
Never close all of the air nozzles of the parking cooler
simultaneously. The device would ice up inside.
I
NOTE
The first time the parking cooler is used, there may be a slight
smell. This is normal and soon goes away.
➤ With the system switched off, press the ON/OFF button (fig. 2 1,
page 4).
I
NOTE
If you completely switch off the parking cooler, it can only be
switched on again using the control panel. The system can only
be switched on using the remote control if it is in standby mode. If
the system is not going to be used for a lengthy period, switch it
off completely so that the battery is not wasted supplying standby
power.
✓ The fan starts at low speed.
✓ The Power LED (fig. 2 8, page 4) lights up.
✓ The digital display (fig. 2 5, page 4) shows the target temperature in °C
and the operating mode (e.g.
20 °C).
I
NOTE
The compressor is switched on after a delay of approx.
90 seconds.
36
for automatic mode + temperature
A20
RT880/SP950
EN