Special Mode (Test Print, Setup Menu; Test Print - Oki PT340 User Manual

9. Special Mode (Test Print, Setup Menu...)

9-1. Test Print

Ensure that paper is set in the printer. Turn off the power switch on the printer,
then turn it on again while pressing the FEED button on the control panel. This
outputs the following printout.
Caution: Press and hold the FEED button until the printer starts
printing.
Special Mode
1.Test Print
2.Setup Menu
3.Hex Dump
4.Command Trace
5.Sample Print
6.End
<Set>
Press FEED button for the number of times
as the same as your selecting item, and
wait more than 1 second.
Dual interface model
Then Press the FEED button once (select 1. Test Print) to start a test print.
The printer automatically cuts the paper and stops after performing a set amount
of printing. To terminate the test print while in progress, press the FEED button.
This cuts the paper and terminates printing.
Special Mode
1.Test Print
2.Setup Menu
3.LAN Setup Menu
4.Hex Dump
5.Command Trace
6.Sample Print
7.End
<Set>
Press FEED button for the number of times
as the same as your selecting item, and
wait more than 1 second.
Triple interface model
42