HP ENVY m7 Maintenance And Service Manual page 73

Models 17-n000 17-n099

Hide thumbs Also See for ENVY m7:

Table of Contents

Remove the cable (2) from the channels in the back cover.

To remove the display hinges:

Remove the two Phillips PM2.5×2.0 screws (1) from the bottom of the hinges, and the two Phillips

PM2.0×2.5 screws (2) from the top of the hinges that secure the display hinges to

the display enclosure.

Remove the display hinges.

If replacing the display cover, be sure that the subcomponents (including the webcam/microphone

module, the antenna receivers, and all associated cables and hardware) are transferred to the new

cover.

Reverse this procedure to install the display assembly.

Component replacement procedures

Table of Contents