Hitachi NT 65GB Technical Data And Service Manual page 44

(6) Disassembly and reassembly of the Blade Guide peripherals
[Tools required]
• Hex. bar wrench (3 mm (0.118"))
• Pin puller
• Hammer
(a) Disassembly
• Turn the Adjuster [80] and remove Pushing Lever (A) [82].
• Remove the Seal Lock Hex. Socket Hd. Bolt M4 x 12 [33], and then remove the Blade Guide
[32] and related parts from the Cylinder [42A].
• Remove the Guide Plate [38] from the Blade Guide [32].
• Remove the Lock Lever Cover [34] by first placing the pin puller at the Roll Pin D3 x 10 [35],
and then striking the puller with a hammer.
• Remove the Lock Lever [36A] by first placing the pin puller at the Roll Pin D3 x 16 [37], and
then striking the puller with a hammer.
(b) Reassembly
• Secure the Lock Lever [36A] to the Guide Plate [38] with the Roll Pin D3 x 16 [37].
• Secure the Lock Lever Cover [34] to the Guide Plate [38]with the Roll Pin D3 x 10 [35].
• Fix the Blade Guide [32] and Guide Plate [38] in place along.
Seal Lock Hex. Socket
Lock Lever Cover [34]
Roll Pin D3 x 10 [35]
Pin [31]
Blade Guide [32]
Hd. Bolt M4 x 12 [33]
Lock Lever [36A]
Roll Pin D3 x 16 [37]
Fig. 39
-41-
Guide Plate [38]