Russound PR-4Z Instruction Manual page 26

b.) Connect an 845 micro emitter to the zone 1 IR output on the rear of the PR-4Z,
and to the IR window of an IR controllable device such as the CD player used in
the above steps.
c.) Using a remote control which is programmed with the devices codes, aim the
remote at the keypad and control the device through the PR-4Z.
(Be sure that the device is not receiving the signal through its own IR receiver).
d.) IR signal should be present on the zone 1 and common output only. (All zones
output IR signal on the common and respective zone outputs only)
20) Repeat steps 9 through 19 for zones 2,3 and 4.
21) Infra-Red control
Change sources on zone 1 through the IR receiver on the front panel. Position the
keypad such that the IR is not going through it.
Cover the front panel IR receiver and change sources on zone 1 through the IR
receiver on the keypad.
22) Paging
a.) Connect a PR-4ZPG Paging Module to the zone 1 page input.
b.) Using the Memory / Preset procedure, preset volume for all zones to half
volume.
c.) Turn down volume all the way in all zones, and select source #5 (VIDEO2) in all
zones.
d.) Using the PR-4ZPG Paging Module, page.
e.) The page should be heard in all zones other than the zone where the page
originates, at the previously set volume (volume should be muted for in the zone
where the page originates).
f.) After the page is complete verify that each zone has returned to the settings in
step 24-c.
23) Repeat steps 24-a through 24-f for zones 2,3 and 4.
24) 115 VAC Switched Outlets
a.) Turn on the PR-4Z, and connect a CD Player's power cord to one of the 2 pole
AC outlets.
b.) Press the All-On button so that all zones are on.