9-54 User's Reference Guide
Or, from the Main Menu, select Easy Setup. The Easy Setup WAN Ethernet Configuration screen appears.
Address Translation Enabled:
Local WAN IP Address:
TO MAIN MENU
Set up the basic IP attributes of your Ethernet Module in this screen.
Toggle Address Translation Enabled to Yes or No (Yes to enable NAT) and press Return.
For more information see
Netopia NAT Behavior"
4.
If your ISP uses numbered (interface-based) routing, select Local WAN IP Address and enter the local WAN
address your ISP gave you. Then select Local WAN IP Mask and enter the WAN subnet mask of the remote
site you will connect to.
The default address is 0.0.0.0, which allows for dynamic addressing, meaning that your ISP assigns an
address via DHCP each time you connect. However, if you want to use static addressing, enter a specific
address.
WAN Ethernet Configuration
Appendix B, "Understanding IP Addressing"
Yes
0.0.0.0
NEXT SCREEN
and
Appendix C, "Understanding
Need help?
Do you have a question about the R910 and is the answer not in the manual?