Navigating Through The Console Screens - Netopia R910 User Reference Manual

6-34 User's Reference Guide
Launch your terminal emulation software and configure the communications software for the values shown in
the table below. These are the default communication parameters that the Netopia R910 uses.
Parameter
Terminal type PC: ANSI-BBS
Mac: ANSI, VT-100, or VT-200
Data bits 8
Parity None
Stop bits 1
Speed Options are: 9600, 19200, or 38400 bits per second
Flow Control None
Note: The router firmware contains an autobaud detection feature. If you are at any screen on the
serial console, you can change your baud rate and press Return (HyperTerminal for the PC requires a
disconnect). The new baud rate is displayed at the bottom of the screen.

Navigating through the console screens

Use your keyboard to navigate the Netopia R910's configuration screens, enter and edit information, and make
choices. The following table lists the keys to use to navigate through the console screens.
Move through selectable items in a screen or pop-up menu
To set a change to a selected item or open a pop-up menu of
options for a selected item like entering an upgrade key
Change a toggle value (Yes/No, On/Off)
Restore an entry or toggle value to its previous value
Move one item up
Move one item down
Display a dump of the device event log
Display a dump of the WAN event log
Refresh the screen
Go to topmost selectable item
Go to bottom right selectable item
Suggested Value
To... Use These Keys...
Up, Down, Left, and Right Arrow
Return or Enter
Tab
Esc
Up arrow or Control + o
Down arrow or Control +k
Control + e
Control + f
Control + L
<
>