Netopia R910 User Reference Manual page 181

addresses.
Note any planned and currently used static addresses before you use DHCP and MacIP.
I
I
Avoid fragmenting your block of IP addresses. For example, try to use a continuous range for the static
addresses you choose.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Block of IP host addresses
(derived from network IP
address + mask issued by ISP)
The figure above shows an example of a block of IP addresses being distributed correctly.
The example follows these rules:
I
An IP address must not be used as a static address if it is also in a range of addresses being distributed
by DHCP or MacIP.
I
A single IP address range is used by all the address-served clients. These include DHCP, BootP, MacIP, and
WAN clients, even though BootP and static MacIP clients might not be considered served.
The address range specified for address-served clients cannot wrap around from the end of the total
I
available range back to the beginning. See below for a further explanation and an example.
I
The network address issued by an ISP cannot be used as a host address.
1
2
4
5
6
7
8
9
10
11
12
13
14
15
16
Understanding IP Addressing B-181
Distributed to the
Netopia R910
(Ethernet IP address)
Manually distributed
(static)
Pool of addresses distributed
by MacIP and DHCP