Default Settings - Atlantis Land A02-AP-W54 Quick Start Manual

1.7.1 IP Adress
This section describes the configuration required by LAN-
attached PCs that communicate with the Wireless Multi-
Function Access Point, either to configure the device or for
network access. These PCs must have an Ethernet
interface (or wireless adapter) installed properly, be
connected to the Wireless Multi-Function Access Point
either directly or through an external repeater hub or by
wireless, and have TCP/IP installed and configured to
obtain an IP address through a DHCP server or a fixed IP
address that must be in the same subnet of the Wireless
Multi-Function Access Point. The default IP address of the
Wireless Multi-Function Access Point is 192.168.1.100 and
subnet mask is 255.255.255.0.
Please follow the steps below for PC's network environment
installation. First of all, please check your PC's network
components. The TCP/IP protocol stack and Ethernet
network adapter must be installed. If not, please refer to MS
Windows related manuals.

1.8 Default Settings

Before configurating this Wireless Multi-Function Access
Point, you need to know the following default settings.
User:
Password:
IP address (192.168.1.100)
Subnet Mask(255.255.255.0)
Wireless: Access Point
SSSID: default
Channel:6
Wireless Multi-Function Access Point