Default Settings - Atlantis Land NetFly WAP 108 A02-WAP-54G(V1.1)_GX01 Quick Start Manual

ENGLISH
The LEDs of the Access Point are clearly visible and the status of the network link
can be seen instantly:
With the power source on, once the device is connected, the Power, LAN and
WLAN port LEDs will light up indicating a normal status.
If the LAN Port's Link indicator does not light up then check the RJ-45 cable if it is
firmly feed to the RJ45 port, while the LAN is link up to the Switch/Hub, the LAN
port's LED will light up.

1.5 Default Settings

The Wireless 108Mbps Access Point can be configured with your Web browser.
The web browser is included as a standard application in following operation
systems, UNIX, Linux, Mac OS, Windows 95/98/NT/2000/Me, etc. The product
provides a very easy and user-friendly interface for configuration.
Before Configuration
This section describes the configuration required by LAN-attached PCs that
communicate with the Wireless 108Mbps Access Point, either to configure the
device, or for network access. These PCs must have an Ethernet interface installed
properly, be connected to the Wireless 108Mbps Access Pointeither directly or
through an external Switch, and have TCP/IP installed and configured with a fixed
IP address that must be in the same subnet of the Wireless 108Mbps Access Point.
The default IP address of the Wireless 108Mbps Access Pointis 192.168.1.1 and
subnet mask is 255.255.255.0.
A02-WAP-54G 23