Default Settings; Password; Lan Wlan; Accessing The Access Point Web Configurator - Atlantis Land A02-AP1-W54 Manual

3.2 Default Settings

Before configuring the Wireless AP through WLAN, make sure that the SSID,
Channel and the WEP was set properly.
The default setting of the Wireless AP that you will use:
User: admin
Password: admin
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Wep Encryption: disable
SSSID: default
Channel:6

3.2.1 Password

When there is a screen needs to enter the Network password, it means that there
is a password settle, type in the password you entered before.

3.2.2 LAN WLAN

The parameters of LAN and WLAN ports are pre-set in the factory. The default
values are shown below.
LAN
IP address
Subnet Mask

3.3 Accessing the Access Point Web Configurator

Before you configure this device, note that when the AP is configured through an
Ethernet connection, make sure the manager PC must be set on same the IP
network. For example, when the default network address of the default IP
address of the AP is 192.168.1.1, then the manager PC should be set at
192.168.1.x (where x is a number between 2 and 254), and the default subnet
mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter IP address http://192.168.1.1 (the factory-default IP address setting) to the
address location.
Wireless Multi-Function Access Point
192.168.1.1
255.255.255.0
A02-AP1-W54
WLAN
Channel=6
SSID=default
Encryption=none
Pag. 13