Starting The Engine - Yamaha YX10ZPSG Owner's Manual

10–20 hours:
Avoid prolonged operation above 6300 r/min.
After break-in:
The vehicle may now be operated normally.
EBU35341

Starting the engine

1. Turn the key to "
ECB02290
NOTICE
The coolant temperature warning light and
6
engine trouble warning light should come
on, then go off.
The EPS warning light should come on,
then go off when the engine is started.
If a warning light does not go off, see page
4-2 for the corresponding warning light
circuit check.
2. Press the brake pedal.
3. Shift the transmission into neutral.
" (on).
 When the transmission is in the neutral
position, the transmission gear display
shows "N" and the neutral indicator
light should come on.
 The engine can be started in any gear if
the clutch pedal is applied. However, it
is recommended to shift into neutral
before starting the engine.
4. With your foot off the accelerator pedal,
start the engine by turning the key to "
(start).
If the engine fails to start, release the key, and
then try starting it again. Wait a few seconds
before the next attempt. Each attempt should
be as short as possible, to preserve battery
energy. NOTICE: Do not crank the engine
more than 5 seconds on each attempt, or
starter damage could occur. Wait at least
5 seconds between each operation of the
electric starter to let it cool.
Do not turn the key to the "
with the engine running; otherwise, damage
to the electric starter may result.
6-2
"
[ECB02140]
" (start) position