Yamaha YX10ZPSG Owner's Manual page 140

6. Install the panel.
To change the transmission oil
1. Park the vehicle on a level surface.
2. Remove panel B (page 8-10).
3. Place an oil pan under the transmission
case to collect the used oil.
4. Remove the transmission oil filler cap,
and then the transmission oil drain bolt
and its gasket to drain the oil from the
transmission case.
8
2
1
1. Transmission oil drain bolt
2. Gasket
5. Install the transmission oil drain bolt and
new gasket, and then tighten the bolt to
the specified torque.
Tightening torque:
Transmission oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
6. Refill with the specified amount of the
recommended oil, and then install the
transmission oil filler cap.
Recommended oil:
SAE 5W-30, 10W-30, 10W-40, 15W-40,
20W-40 or 20W-50
Oil quantity:
1.50 L (1.59 US qt, 1.32 Imp.qt)
TIP
Be sure to wipe up any spilled oil.
7. Start the engine and drive the vehicle for
a few minutes to circulate the transmis-
sion oil.
8-27