Yamaha YX10ZPSG Owner's Manual page 135

1. O-ring
8. Install the new oil filter cartridge with an
oil filter wrench, and then tighten it to the
specified torque with a torque wrench.
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12 ft·lbf)
1
1. Torque wrench
9. Install the drain bolts, and then add the
TIP
Refer to steps 10–18 of the "To change the
engine oil" section for the oil filling procedure.
10. While sliding the front portion of the cen-
8-22
1
specified amount of the recommended
engine oil. Check the engine oil level and
the vehicle for oil leakage. Install the en-
gine oil tank cover and panel C.
ter bottom panel on top of the front bot-
tom panel, fit the slots in the center
8