Installing The Server In The Rack - IBM x3850 X6 Installation Instructions Manual

4. Repeat step 1 on page 9 through step 3 on page 9 for the right rail.
5. Install the M5 hex head screws from the rail kit to secure the rails to the rack

Installing the server in the rack

This topic provides information on how to install the server in the rack cabinet.
About this task
Note: These instructions apply to both the 4U and the 8U server models. Only the
4U is shown in the illustrations.
To install the server in the rack cabinet, complete the following steps:
10
System x3850 X6 and x3950 X6 Types 3837 and 3839: Rack Installation Instructions
EIA flange:
a. At the front of the rack, install an M5 hex head screw in the lower threaded
hole on the front of each rail (two screws required, one in the right rail and
one in the left rail).
b. At the rear of the rack, install an M5 hex head screw in the upper threaded
hole on the rear of each rail (two screws required, one in the right rail and
one in the left rail).
c. Tighten the front and rear rail screws to 30 in-lbs.