Verifying Tcp/Ip Properties; Configuring A Macintosh For Tcp/Ip Networking; Configuring Macos 8.6 Or 9.X For Tcp/Ip Networking - NETGEAR DM602 Reference Manual

Reference Manual for the Model DM602 ADSL Modem
Click OK and close all Network and Dialup Connections windows.
7.
Make sure your PC is connected to the modem, then reboot your PC.
8.

Verifying TCP/IP Properties

To check your PC's TCP/IP configuration:
On the Windows taskbar, click the Start button, and then click Run.
1.
The Run window opens.
Type and then click OK.
2.
cmd
A command window opens
Type
3.
ipconfig /all
Your IP Configuration information will be listed, and should match the values below if you are
using the default TCP/IP settings that NETGEAR recommends:
• IP addresses—192.168.0.2 through 192.168.0.253
• The subnet mask is 255.255.255.0
• The default gateway is 192.168.0.1
Type
4.
exit

Configuring A Macintosh for TCP/IP Networking

Beginning with Macintosh Operating System 7, TCP/IP is already installed on the Macintosh. On
the Macintosh, you will need to configure TCP/IP to use DHCP.

Configuring MacOS 8.6 or 9.x for TCP/IP Networking

From the Apple menu, select Control Panels, then TCP/IP.
1.
3-6 Preparing Your Computer