7
7 . 1 AIR DISTRIBUTION MODULE FITTING
Carefully unpack the module and fit the clips in the frame
c o r n e r s .
7 . 2 FILTER INSTALLATION
Place the air intake grille hinges in the openings marked A
then close the grille with the locks on both sides.
A
K INST. MENU
Air distribution
D i s p l a y
Present the frame to the unit, and apply pressure so that
the clips engage. Then screw it in place.
The seals are illustrated in the diagram below. They avoid:
A
Air by pass
B
Treated air being distributed into the suspended ceiling
s p a c e .
A
A
After installation, check that the gap between the frame
and the suspended ceiling is less than 5 mm .
Avoid bending the frame with excessive pulling. The frame
must be correctly centred in relation to the suspended
ceiling and, above all, it must provide an hermetic
separation between the air intake and the air distribution.
Cassettes
B
B
2 1