Air Distribution; Air Distribution Module Fitting; Filter Installation - Airwell K 9 OG LN Installation And Maintenance Manual

14. AIR DISTRIBUTION

14.1. AIR DISTRIBUTION MODULE FITTING

Carefully unpack the module and fit the clips in the frame corners.
For infra red models, connect the flat cable from the receiver.
Present the frame to the unit, and apply pressure so that the clips engage. Then screw
it in place.
Avoid distorsions of the frame caused by excessive traction; the frame should be correctly
centered in relation to the false ceiling and it should especially ensure an airtight
separation between air succion and air discharge.
The seals are illustrated in the diagram below. They avoid:
A Air by pass
B Treated air being distributed into the suspended ceilling space.
After installation, check that the gap between the frame and the suspended
ceiling is less than 5 mm.
A

14.2. FILTER INSTALLATION

Place the air intake grille hinges in the openings: rep A
Install the filter in the location provided: rep B
Close the grille with the locks on both sides.
A
B
B
18