Maintenance And Daily Cleaning; Service Programme - Siemens TK 56 Operating Instructions Manual

en

Risk of scalding Risk of scalding
!
When the dial 8 is set to
9 may sputter a little. Escaping steam is
very hot and may cause liquid to sputter.
Do not touch the nozzle 9 or aim it at
anyone.
● End the process by turning the dial 8
back to " " O". .
Note: When the nozzle 9 has cooled down,
clean immediately. Dried residue is difficult
to remove.
Maintenance and daily
cleaning

Risk of electric shock
!
Unplug the appliance before cleaning it.
Never immerse the appliance in water. Do
not use a steam cleaner.
● Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
● Always remove any limescale,
coffee, milk or descaling fluid residue
immediately. Such residue can cause
corrosion.
● Wash all removable parts by hand only.
● Rinse out the water tank 1 with water
only.
● Remove, empty and clean the trays for
coffee grounds 0 and residual water 1.
● Wipe out the inside of the appliance (tray
holders).
N.B.: If the appliance is cold when switched
on, or if it is switched to "eco" mode after
dispensing coffee, it rinses automatically; in
other words the system cleans itself.
Nozzle 9 for hot water/steam
● Unscrew the nozzle 9 from the steam
pipe.
● Dismantle all parts (Fig. E).
● Clean with a caustic cleaning solution and
a soft brush. Clean the tip of the nozzle
9c with a blunt needle.
● Thoroughly rinse and dry all parts.
18
Brewing unit
The brewing unit can be removed for
/ , the nozzle
g h
cleaning (Fig. D).
● Press the eco button to start the
● Turn the power on/off switch 1 to 0.
● Open the door 17 to the brewing unit 18.
● Hold the red button 18a down and push
● Grasp the brewing unit 18 by the handle,
● Vacuum the inside of the appliance, or
● Reinsert the brewing unit 18 all the way
● Hold the red button 18a down and push
● Close the doors of the brewing unit.

Service programme:

Combined cleaning and
descaling process
If an "
appliance is on, the service programme
must be run immediately to clean and
descale the appliance. If the service
programme is not run as instructed, the
appliance may be damaged.
Specially­developed descaling (order no.
310451) and cleaning agents (order no.
310575) are included with the appliance
and can also be obtained from customer
service.
automatic rinse cycle.
the handle 18b up until you hear it
engage.
remove carefully, and rinse under running
water. Do not use cleaning agents. Do not
place in the dishwasher.
clean it with a damp cloth.
into the appliance.
the handle 18b down as far as it goes,
until you hear it engage. The brewing unit
is now secure.
" is shown on the display while the
S