Table of Contents
Advertisement
Examples of SCSI Connections
Some examples of standard SCSI connections are illustrated in the following pages. These
do not include all possible disk/media device configurations, but they should represent an
easy template to help you perform the SCSI connections inside the base unit.
For each example, both the SCSI controller to bulkhead connections (on the system left
side) and the bulkhead to device area connections (on the system right side) are illustrated.
It is assumed that any SCSI cables inside the system unit are properly in place.
For details on SCSI cables and bulkhead locations mentioned in these examples, please
refer to SCSI Cables Description and Connection, in the Maintenance Guide.
Note: The examples given in the following pages refer to the base unit only. If your system
configuration includes also one or more disk units, you can find the relevant
examples in the Disk Expansion Unit Service Guide.
• Media Device in Area 1 (CD-ROM), on page 5-13
• Media Devices in Area 1/Area 2, on page 5-14
• Disk Devices in Area 5, on page 5-15
• Disk Devices in Area 5/Area 4, on page 5-16
• Disk Devices in Area 3, on page 5-17
• Disk Devices in Area 3/Area 2, on page 5-18
• RAID Controller Managing Two SCSI Busses, on page 5-19
• RAID Controller Managing One SCSI Bus, on page 5-20
• Connection in Native High Availability Configuration, on page 5-21.
5-12
Setup Guide
Advertisement
Table of Contents
