L/D Lock Lever; Brake Belt (Sp), Belt Holder - Mitsubishi hs-u778 Service Manual

2-22.L/D LOCK LEVER

SET POSITION : Normal
Remove the following parts before replacing the L/D
LOCK LEVER. Refer to the corresponding items to install
them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
• MOTOR HOLDER (Item 2-16)
• PINCH ARM CAP (Item 2-17)
• PINCH ASSY (Item 2-17)
• BRAKE CAM PLATE (Item 2-19)
(Removal)
1. Remove the L/D LOCK LEVER shown in the Fig. 2-22.
(Installation)
1. Install the L/D LOCK LEVER shown in Fig. 2-22.

2-23.BRAKE BELT (SP), BELT HOLDER

SET POSITION : Normal
Remove the following parts before replacing the BRAKE
BELT (SP), BELT HOLDER. Refer to the corresponding
items to install them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
(Removal)
1. Lift the BRAKE BELT (SP) shown in the Fig. 2-23 to
remove it from the REEL DISK (SP side).
2. Release the BRAKE BELT (SP) from the catch (a) of
the BELT LEVER shown in the Fig. 2-23.
3. Release the two catches (b) of the BELT HOLDER
shown in the Fig. 2-23 and separate the BELT
HOLDER from the BRAKE BELT (SP).
4. Release the catch (c) of the BELT HOLDER shown in
the Fig. 2-23 to remove the BRAKE BELT (SP).
(Installation)
Note : Install the BRAKE BELT (SP) so that its Felt Side
touches the REEL DISK (SP side). GREASE
applied to the BRAKE CAM PLATE and MAIN
PLATE ASSY should not adhere on the Felt Side
of the BRAKE BELT (SP).
1. Install the BRAKE BELT (SP) shown in the Fig. 2-23
to the catch (c) of the BELT HOLDER.
2. Install the BELT HOLDER shown in the Fig. 2-23.
3. Install the BRAKE BELT (SP) shown in the Fig. 2-23
to the catch (a) of the BELT LEVER.
4. Hook the BRAKE BELT (SP) shown in the Fig. 2-23 to
the REEL DISK (SP side).
L/D LOCK LEVER
c
a
REEL DISK (SP side)
- 17 -
Fig. 2-22
b
BELT HOLDER
BRAKE BELT (SP)
BELT LEVER
Fig. 2-23