Preparation; Preparing And Using The Remote Control; Batteries For Remote Control - Sharp LC-13S1H Operation Manual

PREPARATION

Preparing and Using the Remote Control

I Use the remote control by pointing it towards the remote
sensor window. Objects between the remote control and
sensor window may prevent proper operation.
Cautions regarding use of remote control
I Do not expose the remote control to shock.
In addition, do not expose the remote control to liquids, and
do not place in an area with high humidity.
I Do not install or place the remote control under direct
sunlight.
The heat may cause deformation of the unit.
I The remote control may not work properly if the remote sensor
window of the main unit is under direct sunlight or strong lighting. In
such case, change the angle of the lighting or LCD TV set, or
operate the remote control closer to the remote sensor window.

Batteries for Remote Control

Before using the LCD TV set for the first time, install two ("AAA" size, UM/SUM-4) batteries (supplied).
When the batteries become depleted and the remote control fails to operate, replace the batteries with
new ("AAA" size, UM/SUM-4) batteries.
1
Open the battery
cover.
I Slide the cover while
pressing the (Y) part.
Caution!
Cautions regarding batteries
Improper use of batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the
instructions below.
• Place batteries with their terminals corresponding to the (+) and (–) indications.
• Different types of batteries have different characteristics. Do not mix batteries of different types.
• Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new
batteries and/or cause old batteries to leak chemicals.
• Remove batteries as soon as they are non-operable.
Chemicals that leak from batteries can cause a rash. If chemical leakage is found, wipe with a
cloth.
• The batteries supplied with the product may have a shorter life expectancy due to storage conditions.
• If the remote control is not used for an extended period of time, remove batteries from the remote
control.
2
Insert two ("AAA" size,
UM/SUM-4) batteries.
I Position the positive and
negative ends of the
batteries as indicated in the
compartment.
POWER OPC HEADPHONE
HEADPHONE jack
OPC indicator
POWER indicator
Remote control
sensor
OPC sensor
3
Close the battery
cover.
I Engage the claw on the
cover into the battery
housing and slide shut.
5