For Your Safety - Weller WX 1 Original Instructions Manual

For your safety

Specified Conditions Of Use
Supply unit for WELLER WX soldering tools. Use
the soldering station / desoldering station / hot air
station exclusively for the purpose indicated in the
operating instructions of soldering and desoldering
under the conditions specified herein.
Flammable gases and liquids may not
be extracted.
The device may only be used with
correctly fitted and suitable filter
cartridges.
Replace filter cartridges when full.
User groups
Due to differing degrees of risk and potential hazards, several work steps may only be performed by
trained experts.
Work step
Default soldering parameters
Replacing electrical replacement parts
Default maintenance intervals
Operation
Filter change
Operation
Filter change
Replacing electrical replacement parts
Starting up the device
Caution!
Please adhere to the operating instructions of
the connected devices.
Put the tool into operation as described in the
chapter „Placing into operation".
Check to see if the mains voltage mat-
ches the ratings on the nameplate.
Make sure the machine is switched off before
plugging in.
Only use the device indoors. Protect against mois-
ture and direct sunlight.
Intended use of the soldering station/ desoldering
station also includes the requirement that you
adhere to these instructions,
„
observe all other accompanying documents,
„
comply with national accident prevention
„
guidelines applicable at the place of use.
The manufacturer will not be liable for unautho-
rised modifications to the device.
User groups
Specialist personnel with technical training
Electricians
Safety expert
Non-specialists
Technical trainees under the guidance and supervision
of a trained expert
After switching on the device, the microprocessor
carries out a self- test and reads out the values of
the parameters stored in the tool.
The set-point temperature and fixed temperatures
are stored in the tool. The actual temperature
value increases to the set-point temperature (=
soldering tool is heated up).
WXA 2: Nitrogen N2 reduces oxidation and flux
remains active for longer. We recommend the
nitrogen N2 that is available in steel bottles. The
bottle must be equipped with a 0-10 bar pressure
reducer.
31