Advertisement
Available languages
Available languages
Charge only using the charger provided with the tool.
u
p
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge the bat-
u
tery in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
Tool shown is EVO143. Other tools are available for use with
this tool head.
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Head release button
4. Bit holder
5. Battery
6. Battery release button
7. Drill/screwdriver head (MTDD6)
8. Torque adjustment collar
9. Chuck
10. Charger
11. Charger indicator
12. Blade
(Original instructions)
13. Jigsaw head
14. Blade clamp
15. Blade clamp lever
16. Shoe
17. Sander head
18. Sanding base
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing the battery (fig. A)
To fit the battery (5), line it up with the receptacle on the
u
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (6) while at
u
the same time pulling the battery out of the receptacle.
Fitting and removing tool heads (fig. B)
Warning! Care must be taken when fitting and removing
heads. Moving parts may become hot during use.
Lock the tool by setting the forward/reverse slider (2) to
u
the centre position.
To remove a tool head, depress the head release button
u
(3) and take the head off the tool.
To fit a tool head, line it up with the tool as shown and
u
push it onto the tool until it snaps into place.
Fitting and removing a drill bit or screwdriver bit
The drill/screwdriver head is fitted with a keyless chuck to
allow for an easy exchange of bits.
Lock the tool by setting the forward/reverse slider (2) to
u
the centre position.
Open the chuck (9) by turning the front part clockwise with
u
one hand while holding the rear part with the other.
Insert the bit shaft into the chuck (9).
u
Firmly tighten the chuck (9) by turning the front part anti-
u
clockwise with one hand while holding the rear part with
the other.
To remove the screwdriver bit from the bit holder, lift the bit
u
from the recess.
To store the screwdriver bit, firmly push it into the holder.
u
Fitting and removing a saw blade (fig. F)
Lock the tool by setting the forward/reverse slider (2) to
u
the centre position.
To fit a saw blade, press the blade clamp lever (15) down
u
(located at the rear of the jigsaw head) and hold it in this
position.
Insert the saw blade into the blade clamp (14) as shown.
u
Make sure that the teeth are pointing to the front.
Release the lever.
u
To remove the saw blade, press the blade clamp lever
u
ENGLISH
9
Advertisement
