Black & Decker Scumbuster Operating Instructions Manual
Table of Contents
- 1 Safety Instructions
- 2 Features
- 3 Additional Safety Instructions for Batteries and Chargers
- 4 Intended Use
- 5 Accessories
- 6 Installation
- 7 Assembly
- 8 Use
- 9 Cleaning and Maintenance
- 10 Hints for Optimum Use
- 11 Protecting the Environment
- 12 Technical Data
- 13 Ec Declaration of Conformity
- Frequently Asked Questions (9)
- Download this manual
Table of Contents
Frequently Asked Questions (9)
-
What surfaces can the Black & Decker Scumbuster safely clean?
The Black & Decker Scumbuster can safely clean various surfaces depending on the attachment used:
- Wide area bristle brush: For aggressive area cleaning on ceramic tile walls and floors, fibreglass and hard plastic surfaces.
- Mild scrub pad (white): For milder scrubbing of large areas, such as ceramic tile walls and floors or outdoor furniture.
- Coarse scrub pad (light blue): For aggressive scrubbing of larger surfaces, such as ceramic tile walls and floors or bath tubs and sinks.
- Heavy scrub pad (green): For aggressive scrubbing on large surfaces, such as barbecue grill grates.
- Radial brush: For tile grout cleaning.
- Narrow brush: For cleaning of corners and hard to reach places.
- Carpet brush: For carpet cleaning.
It can also be used with a variety of cleaning agents for areas like bathrooms, automotive, patio furniture, and other common household cleaners. Always test on a small inconspicuous patch if unsure about a particular surface.
-
What should I do if my Black & Decker Scumbuster is not charging?
If your Black & Decker Scumbuster is not charging, you should regularly check the charger plug for damage and replace the charger if the plug is damaged or defective. Have any damaged or defective parts repaired or replaced by an authorised repair agent. You should not attempt to charge damaged batteries.
For more information, see page 5 of the manual. -
How should I clean and maintain my Black & Decker Scumbuster after use?
After use, you should:
- Unplug the charger before cleaning.
- Store the appliance indoors in a dry place when not in use.
- Regularly clean the motor unit with a damp cloth; do not use abrasive or solvent-based cleaners.
- Clean accessories in soapy water after every use.
- Clean the liquid dispensing system after every use and before storage.
- To clean the liquid reservoir, remove its cap, empty it, and wipe the inside with a soft damp cloth and flush with water.
- To clean the nozzle, loosen and remove it using the cleaning tool, immerse it in warm water for half an hour, and clean the grooves with a fine synthetic brush. Then re-fit the nozzle and dispense clear water until the reservoir is empty, repeating 1 or 2 times.
- To clean the dispensing system, loosen and remove the nozzle using the cleaning tool, fill the reservoir with warm water, and dispense the liquid until the reservoir is empty, repeating 1 or 2 times. Then re-fit the nozzle.
-
What are the recommended uses for the different attachments of the Black & Decker Scumbuster?
The recommended uses for the different attachments are:
- Wide area bristle brush: For aggressive area cleaning on ceramic tile walls and floors, fibreglass and hard plastic surfaces.
- Pad disc: For use with pads.
- Mild scrub pad (white): For milder scrubbing of large areas, such as ceramic tile walls and floors or outdoor furniture.
- Coarse scrub pad (light blue): For aggressive scrubbing of larger surfaces, such as ceramic tile walls and floors or bath tubs and sinks (porcelain or enamel).
- Heavy scrub pad (green): For aggressive scrubbing on large surfaces, such as barbecue grill grates.
- Radial brush: For tile grout cleaning.
- Narrow brush: For cleaning of corners and hard to reach places.
- Carpet brush: For carpet cleaning.
- Flexible attachment: For use of brushes and scrub pads in curved places. Note that the flexible attachment should never be used without a brush or scrub pad in place and not for carpet cleaning.
For more information, see page 6 of the manual. -
How do you change the scrubbing pads or brushes on the Black & Decker Scumbuster?
To change scrubbing pads or brushes:
- Fitting: If using a pad, fit the pad onto the pad disc. Align the triangular notch on the accessory with the shaft on the motor unit. Place the accessory onto the shaft, then snap and twist the accessory quickly in the clockwise direction.
- Removing: Snap and twist the accessory quickly in the counterclockwise direction and pull it off the motor unit.
For more information, see page 6 of the manual. -
Can the Black & Decker Scumbuster be submerged in water?
No, you should not immerse the appliance in water. Additionally, you should not expose the battery to water or the charger to water.
For more information, see page 5 of the manual. -
How does the cordless wet scrubbing function of the Black & Decker Scumbuster operate?
The Black & Decker Scumbuster is designed for wet and dry cleaning purposes. To operate the wet scrubbing function:
- Fill the liquid reservoir with water-like household cleaning agents, ensuring not to use gels or soft scrubs as they can clog the dispensing system.
- Press the dispense button to release the liquid; it will continue to dispense as long as the button is held down.
- Switch the appliance on using the on/off switch, selecting position 1 for low speed or position 2 for high speed.
-
What attachments or accessories come with the Black & Decker Scumbuster set?
The Black & Decker Scumbuster set comes with the following accessories:
- Wide area bristle brush
- Pad disc
- Mild scrub pad (white)
- Coarse scrub pad (light blue)
- Heavy scrub pad (green)
- Radial brush
- Narrow brush
- Carpet brush
- Flexible attachment
- Carrying caddy
- Wall mount
- Cleaning stick
For more information, see page 6 of the manual. -
How do I know when the Black & Decker Scumbuster is fully charged?
When charging the battery, the indicator light on the charger will be lit and will stay lit as long as the battery is connected to the charger. The appliance can be left connected to the charger indefinitely.
For more information, see page 6 of the manual.
Related Manuals for Black & Decker Scumbuster
Summary of Contents for Black & Decker Scumbuster
- Page 1 Ireland Australia New Zealand...
- Page 2 20 17...
- Page 4 24 23...
-
Page 5: Intended Use
Intended use Additional safety instructions for batteries and chargers ® Your Black & Decker Scumbuster has been designed for wet and dry cleaning purposes. This product is intended for Batteries household use only. Never attempt to open for any reason. - Page 6 4. Scrub pad & disc Fitting and removing an accessory (fig. C) 5. Liquid reservoir 6. Charger connector Fitting When using a pad, fit the pad onto the pad disc. Accessories (fig. A) Align the triangular notch on the accessory with the shaft This product is supplied with the following accessories: on the motor unit.
-
Page 7: Cleaning And Maintenance
Cleaning and maintenance Filling the liquid reservoir (fig. F) Fill the appliance only with water-like household cleaning Regularly clean the motor unit using a damp cloth. agents. Do not fill the appliance with gels or soft scrubs as Do not use any abrasive or solvent-based cleaner. they will clog the dispensing system. -
Page 8: Ec Declaration Of Conformity
EC declaration of conformity Should you find one day that your Black & Decker product needs replacement, or if it is of no further use to you, do not S600 dispose of it with household waste. Make this product Black & Decker declares that these products conform to: available for separate collection. - Page 12 Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker Tel. 09 579 7600 81 Hugo Johnston Drive Fax 09 579 8200 Penrose, Auckland, New Zealand United Kingdom Black &...
Need help?
Do you have a question about the Scumbuster and is the answer not in the manual?
Questions and answers