Table of Contents
Advertisement
Boot Order
The
menu specifies the order in which the BIOS tries the various mass memory devices for a bootable
operating system. Boot over LAN is also supported.
Trouble Shooting BIOS Settings
It may happen that the BIOS is configured that the Cool SpaceRunner-LX800 does not start at all. To repair this,
the default values of the BIOS can be automatically loaded at boot time. To load these, the power must be
switched on and off again within 2 seconds. This sequence must be repeated 5 times, and then the default values
get loaded by the BIOS.
Power
1
On
Off
≤ 2s
Pressing the Reset-Button five times while the system is booting achieves the same result.
If there is a power down during an upgrade of the BIOS or if a wrong software version has been erroneously
flashed, there is the possibility to use a Recovery BIOS.
Next to the PC104 header is a connector to plug in a Recovery BIOS on the LPC bus. The pin assignment can be
found at chapter 3.17. If such a recovery BIOS is connected and thus a firmware hub present, this recovery BIOS
will be used to boot the computer instead of the SPI BIOS.
The SPI BIOS is then disabled and can be reprogrammed with a Linux/DOS-based tool provided by Lippert..
TME-104P-CSR-LX800-R1V11.doc
2
3
Rev 1.11
4
5
41 (50)
- Quick Links:
- Block Diagram
- Connector Locations
- Vga Connector
Hide quick links:
Advertisement
Table of Contents
