Speaker; External Power-Button - Lippert Cool SpaceRunner LX800 Technical Manual

3.12 Speaker

The speaker signal is located on the IDC10 Header PS/2. A standard PC
Speaker can be connected between the signal SPEAKER and VCCKB.
Connector type:
Matching connector:

3.13 External Power-Button

The Power-Button signal is located on the IDC10 Header PS/2. To power up/down the board the signal Power-
Button must be pulled to GND. It is not available in standard configuration.
Connector type:
Matching connector:
0.5 A is the maximum current for each pin; power supply will be switched off in standby mode
12
TME-104P-CSR-LX800-R1V11.doc
IDC10 pin header 2.54 mm
IDC10 pin female connector 2.54 mm
Pin Signal
1 Speaker
3 Reset-In
5 KB Data
7 GND
9 Ext. Battery
IDC10 pin header 2.54 mm
IDC10 pin female connector 2.54 mm
Pin Signal
1 Speaker
3 Reset-In
5 KB Data
7 GND
9 Ext. Battery
Pin Signal
2 Mouse Clock
4 Mouse Data
6 KB Clock
8 +5 Volt Switched
10 Power Button (default)/
Reset-In
Pin Signal
2 Mouse Clock
4 Mouse Data
6 KB Clock
8 +5 Volt Switched
10 Power Button
Rev 1.11
12
X16
X16
26 (50)