Removing And Cleaning The Parts; Before Cleaning; How To Clean; Shelf Installation - Mitsubishi MR-BX52W-N-P Operating Instructions Manual

Removing and Cleaning the
Parts
1
Step Step

Before cleaning

Remove the power plug.
Wait at least 10 minutes before reinserting the power
plug into the socket.
If you insert the plug immediately, the mechanism
will not function.
AUTO Shelf
Tray removal
Push up the tray while pulling the 3
white tabs on the rear of the tray to the
front with your fi nger.
Lift up the rear of the tray until the 3
front tabs and the 2 side tabs disengage.
* There is a risk of the tray falling.
Move it slowly.
Pull out with both hands.
Two-way fl exishelf
Push in and lift up.
30
Warning
Otherwise an electric
shock or injury may be
caused.
(Do not disassemble the AUTO Shelf, or use chemicals such as grease to clean it. Doing so may cause a malfunction.)
Shelf removal
Remove the tray before
performing this.
Move the lever to the right end.
Strongly push up each support,
one by one. (4 locations.)
(A clicking sound is made when
the support disengages.)
If the supports are fi rmly set and
diffi cult to disengage, tilt the
inner tabs to the inner side.
Remove from the refrigerator.
2
Step Step

How to clean

Wipe with a soft cloth soaked in warm water, or remove and rinse with
(Wipe the operation panel with a soft, dry cloth.)
For stubborn dirt, wipe using water mixed with a weak concentration of kitchen
In particular, be sure to wipe off oily dirt because leaving it may damage
Do not use alkaline or low alkaline kitchen detergents,
alcohol, benzene, thinner, petroleum, acid, scrubbers, boiling
Doing so may cause the plastic parts (such as the door
or damage or rust the door handles or painted surfaces.
Slide chilled case and small item case (Upper) (Lower)
Fully pull out the case.
Lift out to the front.

Shelf installation

Remove the tray before performing this.
Make sure that the lever is on the right side.
Make sure that the 4 metal stoppers are
fi tted, and place the shelf lightly so that the 4
supports are aligned with the 4 metal stoppers.
Push in each of the 4 supports in turn
from above. (A clicking sound is made.)
Move the lever to the left and right
and check that the AUTO Shelf is kept
level when moved up and down. (If
the shelf is not kept level, remove the
AUTO Shelf and repeat steps
* Cannot replace
to .)
the small item
case (upper) with
the small item
case (lower).