Mitsubishi MR-BX52W-N-P Operating Instructions Manual page 29

Do not use the following for cleaning.
Items such as sponges or scrubbers that may damage surfaces, or cleaners such as alkaline detergents, scouring powder,
boiling water, petroleum or acid
Tank pipe, water supply pump, optical catalyst and lead-cleaning fi lter
once a
week
1
Pull out the tank packing from
the water tank.
2
Pull out the tank pipe, and
rotate and remove the water
supply pump.
3
Disassemble the parts
and wash them.
The impeller is
made from a
magnet.
Wash it thoroughly
to remove any
foreign objects.
4
Return the water supply pump, tank pipe, tank
packing to their original positions.
Procedures for returning the water supply
pump and tank pipe to their original positions
Assembling the water supply pump
1
Fit the fi lter into the cap.
Completed
view
2
Fit the lid onto the cap.
Completed
view
3
Attach the impeller onto
the water supply pump.
Completed
view
If the tank packing is not installed, it may cause the water in the water tank or food in the refrigerator compartment to freeze.
Replacement is not usually required for the optical catalyst and lead-cleaning fi lter. However, it may require
replacement in the following cases.
Note
• When it clogs because something other than water was put in the tank
• When it is damaged
To purchase a new fi lter, contact the retail store where you purchased the refrigerator.
* If mold forms easily in the certain types of water, clean about 2 or 3 times a month.
Water
supply
pump
Tank packing
Tank pipe
Water
supply pump
Cap
Impeller
4
Rotate and fi x the tab ( ) of the
cap into the projection ( ) on
the water supply pump.
* Make sure that the impeller is inside.
Rotate
5
Rotate and set the water supply
pump onto the water tank.
* Align the triangle
mark on the
bottom of the
water tank with
the triangle mark
on the fi lter and
push in while
making sure that
there is no gap.
• When mold has formed
Tank
When setting,
Pipe
align the triangle
mark on the
tank with the
triangle mark on
the packing and
fully put them
together.
Do not use cleaners such as kitchen
detergents (neutral), benzene or
bleach to clean the optical catalyst
Optical
and lead-cleaning fi lter.
catalyst and
Doing so may result in odors of the ice.
lead-cleaning
fi lter
Remove the
Lid
cap while
opening the
tab with your
fi nger.
Incorrect assembly may prevent ice from forming,
or increase the operation noise.
Installing the tank pipe
1
Insert the tank pipe into the water
tank.
Completed
view
2
Connect the tank pipe to the water
supply pump.
Rotate
* Check that
there are
no foreign
objects
between
the tank
pipe and the
water supply
pump.
Tank
Packing
Tank pipe
Water supply pump
Caution
Do not let foreign
objects block the
hole.
Water
supply
pump
Tank
Pipe
29