Declaration Of Conformity - Bosch GCM 10 S Professional Original Instructions Manual

OBJ_BUCH-1126-002.book Page 35 Thursday, July 29, 2010 12:07 PM

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 13.01.2010
Assembly
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Delivery Scope
Carefully remove all parts included in the deliv-
ery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Sliding mitre saw with premounted saw
blade
– Locking knob 13
– Dust bag 1
– Quick-action clamp 22
– Extraction adapter 27
– Allen key/Phillips screwdriver 30
– Ring/open-end spanner 35
Bosch Power Tools
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Mounting the Locking Knob
(see figure A)
– Screw the locking knob 13 into the corre-
sponding drill hole above the lever 14.
Always tighten the locking knob 13 firmly
before sawing. Otherwise the saw blade can
become wedged in the workpiece.
Stationary or Flexible Mounting
To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
Mounting to a Working Surface
(see figures B1–B2)
– Fasten the power tool with suitable screw
fasteners to the working surface. The holes
18 serve for this purpose.
or
– Clamp the power tool with commercially
available screw clamps by the feet to the
working surface.
Mounting to a Bosch Saw Stand
With the height-adjustable legs, Bosch GTA saw
stands provide firm support for the power tool
on any surface. The workpiece supports of the
saw stand are used for underlaying long work-
pieces.
Read all safety warnings and instructions
included with the worktable. Failure of ob-
serving safety warnings and instructions can
lead to electrical shock, fire and/or cause se-
rious injuries.
1 609 929 X03 | (29/7/10)
English | 35