Encore 1102771A Customer Product Manual page 67

E 2010 Nordson Corporation
Gun Re-assembly
16. See Figure 5-14. Insert the outlet tube (14) with O-rings installed
through the front of the gun body until the end is even with the end of
the gun body.
17. Make sure the O-ring is installed in the groove on the inlet powder tube.
Install the elbow (13) onto the end of the inlet tube.
18. Align the gun body assembly with the handle and slide them together,
engaging the internal ribs of the gun body with the tabs in the handle.
14
Internal Ribs
Handle Tabs
Figure 5-14 Outlet Powder Tube Installation
13. Elbow
19. See Figure 5-4. Install the M5 x 10 flat head nylon screw into the gun
body to secure it to the handle.
20. Align the inside end of the powder tube with the elbow then push on the
tube to seat it in the elbow.
21. Connect the J2 cable connector to the power supply connector.
22. Install the display module as described in Display Module Replacement
on page 5-1. Make sure you remove both liners from the trigger switch
header before connecting it to the display module.
23. See Figure 5-3. Install the electrode assembly into the front of the gun
body. Make sure the electrode is not bent or broken.
24. Install the nozzle on the electrode assembly, making sure the keys in the
electrode assembly slide into the slots on the nozzle.
(contd)
14. Outlet powder tube
5-11
Repair
13
Part 1102771A