Encore 1102771A Customer Product Manual page 62

5-6
Repair
13
Figure 5-6 Removing the Elbow and Separating the Base from the Handle
4A. Clear 4-mm tubing
12. M3 x 20 screws
Part 1102771A
7. See Figure 5-6. Remove the elbow (13) from the inlet tube (23).
8. Remove the two M3 x 20 screws (12) securing the handle base (22) to
the handle assembly.
9. Pull the base away from the handle assembly about 25--50 mm
(1--2 in.).
10. Pull the clear 4-mm tubing (4A, part of filter assembly) off the barbed
fitting (20).
23 22 12
13. Elbow
20. Dual barbed fitting
11. See Figure 5-7. Gently pull the ground pad (27) away from the handle,
starting with the bottom and rotating it up and away.
Figure 5-7 Removing the Ground Pad
12. See Figure 5-8. Remove the M3 x 6 screw and M3 lockwasher (27A,
27B) and disconnect the ring-tong ground terminal (part of cable, 28)
from the ground pad (27).
13. See Figure 5-9. Separate the right and left handles (25, 26).
14. Remove the main trigger, settings trigger, and trigger actuator (16, 17,
18) from the right handle half.
23 20 4A
22. Handle base
23. Inlet tube
27
20
E 2010 Nordson Corporation