Encore 1102771A Customer Product Manual page 58

5-2
Repair
10
9
A
Figure 5-1 Display Module Replacement
9. Display module
10. Hook
Part 1102771A
Display Module Installation
4. Remove the liner from the new adhesive support pad and install it over
the trigger switch header. Apply even pressure on the support pad to
seal it to the display module.
5. Connect the J3 display module and cable connector together. The
display module ground connector (A) is not used for this version of the
gun.
6. Gently fold the trigger switch ribbon cable and display module cable into
the gun, and install the display module onto the gun.
7. Slide the hook (10) onto the display module, then install the bezel (11).
8. Secure the module with the screws (12).
11
Display Module and Cable J3 Connectors
Switch
Header
11. Bezel
12. M3 x 35 screws
(contd)
12
Remove 2 liners
(new switch)
12
Adhesive
Support Pad
A. Ground wire connector
E 2010 Nordson Corporation