Encore 1102771A Customer Product Manual page 65

23
20 22
Figure 5-11 Assembling Handles and Base
20. Dual barbed fitting
22. Handle base
E 2010 Nordson Corporation
Gun Re-assembly
5. Align the right and left handle hex pins with their mating sockets and
press the handles together.
6. See Figure 5-11. Feed the cable connectors and ground wire into the
front of the handle, then slide the inlet tube through the tube guides into
the handle assembly while routing the cable through the handle as
shown. Stop when the base is about 1.5--2 inches from the bottom of
the handle assembly.
7. Connect the 4-mm clear tubing (part of filter assembly, item 4) to the
barbed fitting (20) in the handle base.
Tube Guides
23. Inlet tube
8. See Figure 5-8. Connect the cable ground terminal to the inside boss of
the ground pad (27) with the lockwasher and screw (27A, 27B).
9. See Figure 5-12. Hook the ground pad (27) behind the locator tabs on
the rear of the handles and rotate the ground pad into position against
the handle assembly.
(contd)
Clear tubing
28. Cable
5-9
Repair
28
Part 1102771A