Encore 1102771A Customer Product Manual page 66

5-10
Repair
27
Figure 5-12 Assembling Ground Pad and Base to Handles
12. M3 x 20 screws
Bulkhead
Figure 5-13 Assembling Bulkhead and Routing Cables
Part 1102771A
10. Push up on the handle base (22) to seat it in the handle, then secure the
handle base to the handle assembly with the two M3 x 20 screws (12).
Hand tighten the screws only.
Locator Tabs
22. Handle base
11. See Figure 5-2. If you removed the power supply, slide it into the upper
cavity of the gun body, guiding the guide ribs inside the gun body
between the mating grooves on the power supply.
12. Press on the end of the power supply to ensure that the contact tip at
the end of the gun body is firmly seated against the brass contact inside
the power supply end.
13. See Figure 5-13. Position the lower edge of the bulkhead (8) behind the
locator tabs in the rear of the handle assembly and rotate the top of the
bulkhead forward until it snaps into place on the handle and gun body.
14. Feed the power supply J2 connector through the top opening in the
bulkhead.
15. Route the trigger switch header and gun cable connectors through the
bottom opening in the bulkhead.
Locator Tabs
27
22
12
27. Ground pad
Power
Supply
Connector
Gun
Cable
Connectors
Trigger
Switch
Header
E 2010 Nordson Corporation