Electrical Connection; Operating The Cleaner - Kärcher HD 855 S Operating Instructions Manual

English
Using the cleaner for the
first time

Electrical connection

Caution!
The voltage specified on the model
rating plate must correspond to the
voltage supplied.
Caution!
Use an extension cable whose cable
cross-section is adequate (see
"Technical Specifications") and
unreel it completely from the cable
drum.
For connected loads see model rating
plate/Technical Specifications.
Water connection/suction
feed operation
Connection to water main
Caution!
Pay attention to the regulations of the
water supply company; according to
DIN 1988, the cleaner may not be
connected direct to the public drink-
ing water supply. A short-term con-
nection via a non-return valve (Order
no. 6.412-578) is allowed.
For connected loads see Technical
Specifications.
n
Connect a supply hose (not supplied) to
the water outlet (15) on the cleaner and
to the water inlet (e.g. water tap).
n
Open water inlet.
Operating Instructions HD 855 S(X) / HD 895 S(X)
Suctioning water from an open
container
n
Screw suction hose with filter (Order no.
4.440-238) to the water outlet.
Venting the unit
n
To vent the unit, unscrew the nozzle and
leave the unit running until the water
exits with no air bubbles.
n
Switch off the unit and screw the nozzle
back on.

Operating the cleaner

Danger!
!
Observe the relative safety
regulations when using the cleaner at
filling stations or other high-risk
areas.
Caution!
Only clean engines in places which
have appropriate oil separators
(protection of the environment).
Caution!
Only wash animals with the low-
pressure fan jet (see "Selecting the
type of spray").
Venting the unit
n
To vent the unit, unscrew the nozzle and
leave the unit running until the water
exits with no air bubbles.
n
Switch off the unit and screw the nozzle
back on.
17