Toshiba 3560 Service Handbook page 55

Explanation of items in the "REMARKS" column of the Periodic Inspection Check List
*1 Main blade
Clean the main blade with a cloth which should be soaked in water and then squeezed tightly. If
poor cleaning occurs due to the adhesion of paper dust, etc., the edge of the blade has been
damaged.
Replace the blade regardless of the number of copies made so far.
*2 Recovery blade
If the edge of the blade is damaged, replace the blade regardless of the number of copies made so
far.
*3 Separation claw
If the tip of the separation claw has been damaged, replace the claw regardless of the number of
copies made so far.
Clean the tip of the claw by lightly wiping with a dry cloth. After cleaning, make sure to remove bits
of lint from the claw. In addition, be sure to apply patting powder (lubricant) to the separation claw
after cleaning the claw and when replacing the claw or drum.
*4 Drum
Refer to section "3.2 Inspection and Cleaning OPC Drum".
*5 Air filter
If the air filter is dirty, replace it.
*6 Charger wire and case
Clean the inner surface of the charger case and the charger wire with a cloth which should be
soaked in water and then squeezed tightly.
*7 Grid
Remove the grid from the main charger. Clean the grid with a pad (service part) moistened with
water.
*8 Developer material
After replacing the developer material, be sure to adjust the corresponding auto-toner sensor.
*9 Front shield
Clean it with a cloth which should be soaked in water and then squeezed tightly.
*10 Heat roller
*11 Pressure roller
*12 Cleaning felt roller
Refer to section "3.4 Checking and Replacing Cleaning Felt Roller" of this Service Handbook.
*13 Scraper
If the tip of any of the scraper claws is chipped, replace it regardless of the number of copies made
so far. If toner adhering to the scraper claw is forcibly scraped off, it may be damaged.
Therefore, if the tip of the claw is heavily coated with toner, replace the claw.
*14 Heat roller cleaning blade
Refer to section "3.6 Checking and Cleaning Heat Roller Cleaning Blade" of this Service Handbook.
3560/70 MAINTENANCE
Refer to section "3.5 Checking and Cleaning Upper and Lower Heater
Roller".
2 - 6 Nov. 1997 © TOSHIBA CORP.