Adjusting The Discharge Chute; Starting The Engine - Power Craft 89034 Instruction Manual

Lubricate the lubricating nipple by the
blade drive using a grease gun.
GB

Adjusting the discharge chute

You can set adjust the direction of discharge
by moving the handle (18) clockwise or
anticlockwise. You can also set how far the
snow will be discharged by altering the flap
angle (8) using the butterfly screw (9). The
steeper the angle, the further the snow will
be discharged.
Adjusting the runners
The runners (12) act as buffers between the
machine and the ground.
If using the machine on a slightly uneven or
loose surface, lower the runners.
Slacken the nuts on each side and push the
runners downwards. Adjust and secure one
runner at a time.
56
Preparation for use
Remove the oil filler cap. Check the oil level
using the dipstick on the underside of the
cap and top up if necessary. Replace the
cap.
Remove the petrol tank filler cap and check
the petrol level (5).
Top up with petrol if the level is too low.
Replace the cap.
Remove the butterfly nut on the top of the
air filter (6), remove the air filter and check
the filter element is clean. Clean the filter
element if necessary (see Cleaning and
maintenance), and refit the filter.

Starting the engine

Open the petrol cock (24).
Set the throttle lever (22) to the maximum
setting and press the primer (21) by the
carburettor 5-6 times to pump fuel into the
engine.
If starting from cold, push the choke (23) in
the direction of the arrow to increase the
fuel mix richness.
Manual start
Gently pull the starter handle until you feel
resistance, and then pull strongly to start
the engine.
NB! Do not allow the starter handle to recoil
freely as the handle may become damaged
upon impact with the machine.