Power Craft 89034 Instruction Manual page 55

Unscrew the adjustment bracket from
the gear cable on one side. Fasten the
adjustment bracket in the hole on the
clutch.
Reattach the gear cable to the adjustment
bracket and adjust it so that its tension is
correct. See Testing the clutch cables.
Push the gear stick (19) in through the gear
link on the handle.
Secure the gear stick to the gear shaft using
a bolt which is pushed horizontally through
the gear stick bracket.
Fit a screw from below and tighten it so
that the gear stick is pressed into one of the
notches in the gear link.
Fit the work light to the bracket on the
handle.
DK
NO
SE
FI
GB
DE
PL
ET
55