Accessing Ngn/Ip Pbx (Mgcp) - Huawei eSpace IAD101H Quick Start Manual

eSpace IAD101H/102H/104H Integrated Access
Device
Quick Start
If the DNS is configured, you can run the sntp server name domain-name command to set
the SNTP server domain name.
2. Run the sntp interval<0-3600> command to set the synchronization interval. If
the synchronization interval is 0, the system time of the IAD does not synchronize
with the SNTP server time.
3. Run the sntp time-zone {+ <0-13> | - <1-12>} command to set the time zone. For
example, to set the Beijing time, which is in the time zone GMT+8.
TERMINAL(config)#sntp time-zone + 8
You can run the display sntp command to view the SNTP server status.
TERMINAL(config)#display sntp
-------------------------------------------------
SNTP server
Local time zone
Synchronization interval : 2Sec.
state
-------------------------------------------------
Step 8
Run the write command to save the settings.
The command is:
TERMINAL(config)#write
----End

4.3 Accessing NGN/IP PBX (MGCP)

The users of the IAD101H/102H/104H register with the softswitch (for example,
Softx3000 and SoftCo) to implement the voice service. After configuring the softswitch
data, configure the IAD101H/102H/104H data to use the voice service, including basic
call and fax services.
Data Plan
In this example, the Softx3000 functions as the MGC server. You can obtain the
connection data between the IAD and the Softx3000 from the network carrier or
network administrator. The following data is for reference only.
Table 4-3 Connection data between the IAD and the Softx3000
Item
Control protocol
used between the
SoftX3000 and the
IAD
Issue 03 (2012-06-11)
: 191.168.10.44
: +8
: available
Parameter Value
MGCP protocol
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (CLI)
Parameter and Value on the
IAD
Protocol mode: MGCP
14