Configuration (Ems) - Huawei eSpace IAD101H Quick Start Manual

eSpace IAD101H/102H/104H Integrated Access
Device
Quick Start
If multiple IADs are available on the network, you can use the Unified Communication
Element Management System (UCEMS) to configure all IADs. To use the UCEMS to
configure and upgrade IADs in a unified manner, you must set the UCEMS connection
parameters on IADs.
CLI Mode
Step 1
Log in to the CLI management system. For details, see eSpace IAD Product
Documentation.
Step 2
Set the IP address or domain name of the UCEMS server.

You can run the nms primary command to set the IP address of the UCEMS server.
For example:
TERMINAL(config)#nms primary 192.168.1.201
If two UCEMS servers are available on the live network, you can run the nms primary
ip-addresssecondary ip-address command to set the IP addresses of both UCEMS
servers. The two servers will work in the active and standby mode. For example:
TERMINAL(config)#nms primary 192.168.1.201 secondary 192.168.1.55

You can also run the nms domain command to set the domain name of the
UCEMS server.
In this mode, only one UCEMS server can be configured.
If the DNS mode is used, ensure that the DNS server is available on the network, and the
DNS server is configured.
Step 3
(Optional) Set other parameters according to
default values.
Table 5-1 UCEMS parameter setting commands
Operation
Set the access
switch of the
UCEMS
Set the domain
name of the
UCEMS
Issue 03 (2012-06-11)
5
Command
nms access
nms domain
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

Configuration (EMS)

Table 4-1. You are advised to retain the
Default Value
on
ucems.com
5 Configuration (EMS)
26