Table of Contents
Advertisement
Quick start for the Turnigy 10XC Charger
Refer to manual for complete operating details.
A. Connect charger to a 12V to 32V (maximum) power source.
B. Connect pack(s) to charger.
Plug pack's balance connector(s) into channel jack(s) on right side of the charger (use balance
connector adapters as needed).
When charging only one pack, plug pack's balance connector into Ch1. Plug pack's discharge
wires into outermost banana jacks on charger's panel.
When charging two packs: Plug discharge wires from Ch1 pack into banana jack pair #1, and plug
discharge wires from Ch2 pack into banana jack pair #2.
When using an unbalanced preset, connect only the pack discharge wires in accordance with bullet
points 2 and 3 above.
C. Configure charger:
To review selected preset's settings: Press MODE button.
To select a different preset: Press MODE button until you see the desired preset's name and
settings in display.
To change selected preset's settings: Press and hold MODE button to set chemistry and/or
charge current. Press and hold to exit.
D. Press START/STOP button for one second to begin charging.
E. During charging:
To view charge data: Press MODE button repeatedly.
To cancel charging at any time: Press START/STOP button for one second.
F. The charger will automatically stop charging, and initiate a series of beeps when charging is
complete.
G. To end charging session and return to Preset Menu, press START/STOP button for one second.
January 17, 2012 ver 1.0 www.revolectrix.com
25
Advertisement
Table of Contents
