Download Print this page

Alternate Charging Modes - Hobby King Turnigy 10XC User Manual

Hide thumbs

Table Of Contents

Table of Contents

mode:

b. Press and release the MODE button to toggle operation between

WIRING

Note: DEFAULT WIRING is the Factory Default mode and provides proper operation when using Turnigy

10XC adapters. XH/EH WIRING mode supports the popular JST XH or EH wiring scheme. See the

section "Balance Connector wiring" below for more information about these wiring schemes.

To set the charger for QUIET CHARGING:

a. Press and hold the MODE button, then release it when the display changes to this:

Note: If you hold the MODE button down longer, you'll see

When you release the MODE button, you'll see the setting for QUIET CHARGING:

b. Press and release the MODE button to turn QUIET CHARGING OFF or ON.

Note: When QUIET CHARGING is turned ON, the charger will not beep to notify you at 99% charge

completion or when the charge is completed. Setting QUIET CHARGING to YES does not disable the

speaker during button presses.

To Exit the Options Menu and return to the Preset Menu:

a. Press and hold the MODE button, then release it when the display changes to this:

Note: If you hold the MODE button down longer, you'll see

above).

When you release the MODE button, you'll see the Preset Menu:

Preset 1

[chem] [BAL] @ [charge current]

Note: Remember, any settings you change while in the Options Menu are automatically saved the instant

you make the change. You may Exit the menu at any time. You may also simply cycle power to the

charger to re-start, in which case the Welcome Screen will appear.